- height adjustable stand (for example, a screw jack);
- inspection pit or overpass.
Left support
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the engine splash guard or crankcase protection (if installed).
3. Place a height-adjustable support (jack) under the gearbox and lift the gearbox slightly, relieving the left support.
4. Using a TORX E14 key with an extension, unscrew the two bolts securing the support to the bracket.
5. Using a 17 mm socket wrench, unscrew the bolt and two nuts securing the support to the body.
6. Remove the support from the studs.
7. If necessary, use a 13 mm socket wrench to loosen the two screws securing the support cushion to the body bracket.
Installation
We install the new support in the reverse order.
Right support
We replace the right support in the same way as the left support (see above).
Rear support
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Install a height-adjustable stand (jack) under the gearbox housing.
3. Using a 17 mm socket wrench, unscrew the two nuts securing the support to the body 1. On the support, lower the rear part of the power unit by 10-15 mm. Using a 19 mm wrench, unscrew bolt 2 securing the support to the bracket.
4. If necessary, remove the protective screen (see "Catalytic collector - removal, gasket replacement, installation") and unscrew the three bolts securing the support bracket to the gearbox housing: two bolts 1 with a 17 mm wrench and one bolt 2 with a 19 mm wrench.
5. Remove the bracket.
Installation
We install the rear support in the reverse order.