1. In the car interior under the dashboard (for clarity, the work is shown with the instrument panel removed) unscrew the nut securing the clutch release cable housing stop to the pedal bracket...
2. ...and remove the stop from the stud.
3. Using a screwdriver, remove the locking bracket from the clutch pedal pin...
4. ...and the housing of the clutch driven disk wear compensation mechanism.
5. Remove the plastic sleeve from the clutch pedal pin and inspect it. Replace a heavily worn or damaged clutch pedal bushing by lubricating it with Litol-24 or LSC-15 grease before installation.
6. In the engine compartment, remove the rubber seal of the clutch release cable sheath from the hole in the front shield.
7. Pull the end of the clutch release cable forward in the direction of vehicle travel to remove the end from the groove in the clutch release fork.
8. Unscrew the leash from the end of the clutch release cable...
9. ... remove the clutch cable housing guide bushing from the hole in the gearbox bracket and remove the clutch cable from the vehicle by pulling it out of the hole in the front shield.
10. To install a new clutch release cable, first pass it through the hole in the front shield and secure the wear compensation mechanism housing to the clutch pedal pin (see points 3 and 4).
11. Secure the clutch cable housing stop to the pedal bracket stud (see points 1 and 2).
12. Install the clutch cable housing seal into the hole in the front shield (see item 6).
13. Pass the clutch cable through the hole in the bracket on the gearbox and install the cable sheath guide bushing into this hole (see item 9).
14. Screw the leash onto the lower end of the clutch cable (see item 8), ensuring that the end protrudes relative to the end of the leash by 0-1 mm.
[Original text on the website LadaMan.ru]
15. Set the clutch drive cable to its original position by overcoming the force of the mechanism spring and moving the lower end of the clutch cable forward in the direction of vehicle movement until it stops. Keeping the tip extended, measure the size L between the clutch fork and the leash, it should be 27 mm. If the size does not correspond to the specified value, set it by rotating the leash in the desired direction.
16. Insert the clutch cable end into the groove of the clutch release fork and release. Under the action of the spring, the tip leash should be installed on the clutch fork without any gap.
17. Press the clutch pedal all the way down three times and measure the distance again L (See item 15). If necessary, repeat the clutch adjustment.