To remove and install the outer handle of the front door on a car, you will need: a socket wrench "8", screwdrivers with a flat and Phillips blade.
1. Remove the door trim (see "Removal and installation the front door trim").
2. Remove four screws...
3. ...and remove the plastic filler from the front door trim.
4. Use a screwdriver to pry up the plastic retainer...
5. ...and remove the lock switch rod from the hole.
6. Unscrew the nut, remove the washer of the front door handle mount...
7. ...and unscrew the bolt of the rear fastening of the front door handle.
8. Remove the handle from the mounting holes in the door...
9. ...disconnect the outer door handle rod from the handle and remove the handle.
10. Press the lock cylinder retainer with a screwdriver (shown in the photo by the arrow) and remove the cylinder from the door handle.
11. Assemble and install the front door handle on the vehicle in the reverse order of removal.
Figure 10.2. Location of the lock, lock drive rods and front door handles: 1 - front door; 2 - lock switch rod; 3 - Front door outer handle; 4 - front door glass; 5 - door lock switch button; 6 - door trim; 7 - Lock switch button rod; 8 - front door lock; 9 - inner front door handle; 10 - internal lock drive rod; 11 - guide; 12 - outer handle rod; 13 - nut; 14 - lock mounting screw