1. Remove the front door trim (see «Removal and installation of a covering of a forward door»).
2. Mark the position of the fixing bracket on the drive rod of the internal door lock...
3.... and separate the rod and bracket.
4. Turn out the screw of fastening of the mechanism of the internal handle of a forward door.
5. Remove the mechanism of the internal handle of a forward door.
6. Disconnect the outer door handle link from the handle (see «Removal, installation and repair of the outer handle of the front door»).
7. Disconnect the lock switch rod from the central lock (see «Removal, installation and repair of the outer handle of the front door»).
8. Turn out three screws of fastening of the central lock to a forward door and take away the lock forward.
9. Disconnect from the lock draft 1 of the button of the switch of the central lock and draft 2 of the internal handle of a forward door.
10. Pull out the plastic retainer...
11.... and disconnect the front door wiring harness connector from the central lock.
12. Remove the central lock from a door.
13. Mark an arrangement of draft of the external handle of a door in a clip of the central lock...
14.... and remove the rod from the clamp.
Note. The central lock of the front door is a non-separable design with an electric drive and is supplied as a whole in spare parts.
15. Turn out screws of fastening of the case of a latch of the central lock of a forward door: the top and lower screws...
16....then socket head middle screw...
17.... and remove the central lock housing.
18. Install the front door central lock on the car in the reverse order, having previously applied VTV-1 grease to its drive rods.