Note: The work is shown with preliminary disassembly of the hood. But if necessary, the hood can be removed as a whole with the elements installed on it. To do this, simply disconnect the hose from the windshield washer pump and pull the hose out of the engine compartment bulkhead seal.
An assistant will be needed to complete the job.
Removal
1. Prepare the car for work (see "Preparing a car for technical inspection and repair").
2. Using a 10 mm socket wrench, unscrew the two nuts 1 securing the hood lock safety hook. Using a 41 mm wrench or sliding pliers, unscrew the hood lock latch 2.
3. Using a screwdriver or puller, remove the hood trim holders.
4. Remove the hood trim.
5. Using a screwdriver, disconnect the washer hose holders from the hood. Having disconnected the hose from the tee, we use a screwdriver to pry up the rubber seal and pull the washer hose out of the hood opening.
6. Through the openings in the hood reinforcement, squeeze the two injector clamps. We remove the nozzle from the hood hole and disconnect the hose from the washer nozzles. We remove the second injector in the same way.
7. Remove two injector hoses with a tee.
Assembly and installation
We assemble and install the hood in the reverse order.