To complete the work you will need a piece of wire with a diameter of 1-1.5 mm (or a large paper clip).
It is more convenient to clean the drainage holes in the thresholds on an inspection ditch or overpass.
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Apply plastic grease to the hood lock retainer and its spring.
3. Lubricate the axle of the safety hook with penetrating lubricant.
4. After opening the door, inject penetrating lubricant into the hinges of its hinges. We lubricate the hinges of the other doors of the car in the same way.
5. Lubricate the keyholes of the door locks with the same preparation.
6. Apply plastic grease to the working surface of the door stops, the spring and the hinge of the fuel tank filler flap.
Note: To remove moisture from the internal cavities, drainage holes are made in the lower parts of the doors and thresholds. Depending on the year of vehicle production, their number may vary.
Data obtained from the website: LADAMAN
7. Use wire to clean the drainage holes in the doors and body sills.
8. To extend the service life of rubber door seals, treat them with silicone grease.
