1. Disconnect the wire from the negative terminal of the battery.
2. Remove the front bumper (see "Removal and installation the radiator grille").
3. Remove the mudguard liner (see "Removal and installation the mudguard").
4. Remove the headlight (see "Headlight replacement").
5. Disconnect the connector with wires from the side turn signal terminals.
6. Remove the hood side bumper.
7. Clean the mastic from the places where it was applied to the joints between the front wing and the body.
8. Remove the two bolts securing the side bracket of the front wing to the front shield...
9. ...and three bolts securing the front wing to the gutter.
10. Remove the bolt securing the rear upper fastening of the front wing to the body...
11. ...and the rear lower fastening of the front wing to the car body and remove the wing from the car.
12. Replace the front fender if necessary.
13. Install the front wing on the vehicle in the reverse order, clean off any corrosion and remove any remaining insulating gaskets from the body surfaces mating with the wing, apply primer to the surfaces cleaned to the metal and then bitumen mastic or insulating gaskets.