Sequence of execution
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the fuel pump circuit fuse (see "Engine Management System Fuses and Relays - Replacement").
Note: You can disconnect the wiring harness from the fuel module (see page 65. "Fuel module - removal and installation").
3. After turning on the starter, turn the crankshaft for 10-15 seconds.
If the engine starts, we wait until all the gasoline in the fuel line is used up and the engine stalls.
4. Turn off the ignition.
5. Install the fuse in place and close it with the cover.
Warning! After releasing the pressure, a small amount of gasoline remains in the fuel line. Avoid contact with hot parts.