Removal
1. Remove the pressure and driven clutch discs (see "Clutch - replacement").
2. Using any available method, mark the position of the flywheel on the shaft (this will make installation easier).
3. Using a 17 mm socket wrench, unscrew the six flywheel mounting bolts, holding it from turning with a mounting blade or screwdriver.
4. Remove the washer and flywheel.
If necessary, remove the upper clutch housing cover from the guide bushings.
Installation
We install the flywheel in the reverse order in accordance with the mark made during disassembly.
Recommendation. Before tightening the flywheel mounting bolts, apply thread locking compound to their threaded portion.
Note: The flywheel must be installed on the crankshaft in only one position. If the mark made has been erased, the flywheel can be installed according to the factory mark - for this purpose, a hole is drilled on the outer side of the flywheel. When installing the flywheel on the crankshaft, the mark should be located opposite the connecting rod journal of the fourth cylinder. Do not confuse the mark with the balancing holes, which are made with a larger diameter drill.
[Taken from the website: LADAman.ru]