Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the door trim (see "Door trim - removal and installation").
3. Raise the glass to the stop and fix the glass in this position (for example, with masking tape).
4. Using a 10 mm socket wrench, unscrew the two bolts securing the glass to each window regulator pillar.
5. Unscrew the screw securing the inner handle of the lock (see "Door lock - removal, installation and adjustment").
6. Cut the insulating tape securing the window lifter wiring harness pads and remove the foam rubber.
7. Disconnect the wiring harness connector of the window lifter motor-reducer.
8. Using a 10 mm socket wrench, unscrew the nuts securing the window regulator to the door amplifier.
9. Remove the window regulator from the door.
Installation
We install the window regulator in the reverse order, having lubricated the window regulator guide with plastic grease. To prevent the wiring harness pads from knocking on uneven surfaces, wrap them with foam rubber and tape them with insulating tape.