1. Disconnect the wire from the negative terminal of the battery.
2. Remove the three mounting screws (shown in the photo by arrows)...
3. ...and remove the parking brake lever trim.
4. Remove the parking brake indicator lamp switch (see "Replacing the Parking Brake Indicator Lamp Switch").
5. Remove the rear screw securing the floor tunnel trim.
6. Remove the gear shift boot from the mounting hole in the floor tunnel trim.
7. Remove the fastening screw...
8. ...and remove the left side panel of the floor tunnel.
9. Remove the right side panel of the floor tunnel in the same manner.
10. Remove the floor tunnel lining plug by prying it off with a screwdriver.
11. Pry up the clamps of the diagnostic connector and lower it down.
12. Remove two screws (shown in the photo by arrows) fasten the engine management system fuse box to the floor tunnel trim and move the box downwards.
13. Remove the left and right screws of the front fastening of the floor tunnel trim.
14. Lift the trim, disconnect the connector with wires from the cigarette lighter...
15. ...and remove the floor tunnel lining.
16. Install the floor tunnel trim on the vehicle in the reverse order of removal.