Removal and installation the ignition coil (Kalina 1118)

To remove, install and replace the ignition coil on a car, you will need a 5 mm Allen key.

1. Disconnect the wire from the negative terminal of the battery.



2. Disconnect the high-voltage wires from the ignition coil.

3. Press the plastic retainer and disconnect the connector with the ignition coil power wires from the ignition coil terminals.

(The original was published on the portal LADAman)



4. Remove the four screws securing the ignition coil to the bracket and remove the ignition coil from the bracket.

5. Replace the faulty ignition coil. Install the ignition coil on the vehicle in the reverse order of removal.