Removing
1. Remove the throttle assembly from the receiver flange studs without disconnecting the cooling system hoses from it (see «Throttle assembly - removal, gasket replacement and installation»).
2. Having loosened the clamp 1, remove the vacuum brake booster hose from the receiver pipe. Using a 10 mm socket wrench, unscrew the three nuts 2 securing the throttle cable bracket.
3. Disconnect the tip of the cable from the throttle sector (see «Throttle assembly - removal, gasket replacement and installation») and take the throttle cable with the bracket to the side.
4. Using a 13 mm socket wrench, unscrew the five nuts securing the receiver to the intake manifold.
5. Remove the receiver from the engine.
6. We remove the rubber o-rings from the grooves of the receiver flange. Replace damaged rings.
Installation
Install the receiver in reverse order.