1. Disconnect the wire from the terminal «minus» battery.
Location of additional fuses and injection system relay: F1 (15 A) – safety lock of a chain of the main relay and blocking of a starter; F2 (7.5 A) - computer power circuit fuse (controller) F3 (15 A) - fuse for the electric fuel pump; K1 - main relay; K2 - relay for switching on the electric fuel pump
2. Remove the right side lining of the floor tunnel (see «Removal and installation of floor tunnel linings»).
3. Disconnect the block with wires from the computer, see. «Electronic engine control unit (controller)»), and take her aside.
4. Using tweezers, remove the defective fuse and replace it with a new one.
5. To replace a faulty relay, unscrew the appropriate nut for its fastening...
6.... and remove the relay assembly with fuses.
7. Remove the fuel pump relay from the block and replace it with a new one. The starter lock relay is replaced in the same way.