Transmission oil change (Vesta 2180)

We carry out the work in accordance with the maintenance plan (see "Maintenance plan") - every 15,000 km. To perform a number of operations, such as replacing the front wheel drive oil seal, you will also need to drain the oil.

At the bottom of the crankcase there is a drain hole, closed with a threaded plug.

To perform the work you will need an inspection ditch or overpass and a special syringe, a new drain plug sealing ring, and an 8 mm square wrench.

Sequence of execution

1. Place the vehicle on an inspection ditch or overpass and prepare it for work (see "Preparing the car for maintenance and repair").

2. Remove the engine mudguard (see "Engine mudguard - removal and installation").

3. Unscrew the plug of the gearbox inspection hole (see above "Manual gearbox - checking the transmission oil level").

4. Using an 8 mm square wrench, unscrew the gearbox drain plug and drain the oil.



5. Put a new sealing ring on the plug. We screw in the plug and tighten it to a torque of 25 Nm.

6. Fill the oil to the lower edge of the inspection hole (see above "Manual gearbox - checking the transmission oil level").