Replacing the throttle cable (Priora 2170)

If the throttle valve does not open fully (the engine does not develop full power) or is closing (increased idle speed), first try adjusting the throttle cable (see "Checking and adjusting the throttle cable"). If the throttle actuator cannot be adjusted to fully open or close the throttle valve, or if the actuator sticks, replace the actuator cable.

You will need: a flat-blade screwdriver, narrow-jaw pliers, and side cutters.

1. Remove the decorative engine cover (see "Removing and installing the decorative engine cover").



2. To replace the throttle drive cable, remove the safety clip from the throttle assembly sector by prying it off with a screwdriver.



3. Remove the cable end from the sector groove and disconnect the cable from the throttle assembly.





4. Remove the spring lock…



5. …and remove the cable from the slots of the holders.



6. Release the cable by cutting the plastic clamp securing the cable to the crankcase ventilation hose with side cutters.



Data taken from the specified website: LadaMan.ru



7. Slide the cable sheath forward…



8. …and remove the cable sheath damper from the hole in the front shield.



9. In the car's interior, under the instrument panel, remove the cable end from the pedal lever pin by sliding it with a screwdriver.

10. Remove the cable into the engine compartment.

11. Install the cable in the reverse order of removal. Don't forget to secure the cable with a new plastic clamp to the crankcase ventilation hose.

12. Adjust the throttle actuator (see "Checking and adjusting the throttle cable").