Oil Pressure Sensor — replacement (Vesta 2180)

A faulty sensor can be detected by checking the oil pressure (see "Oil pressure"), checking it on a special stand or replacing it with a known good one.

Sequence of execution

1. Prepare the car for work (see "Preparing the car for maintenance and repair").

2. Remove the decorative trim (see "Engine trim panel - removal and installation").

3. Squeeze the protrusions of the wire connector block on both sides and remove the block from the emergency oil pressure sensor.



[The text of the article was taken from the website LadaMan]

4. Using a socket wrench or a 21 mm deep head, unscrew the sensor and remove it.

Installation

1. Install the sensor in reverse order.

2. Start the engine and make sure there are no oil leaks from under the sensor. If necessary, replace the sensor sealing ring or the sensor assembly.