Engine trim panel — removal and installation (Vesta 2180)

The decorative trim is held in place by four rubber couplings that fit onto the studs of the intake module cover.

Removal

1. Prepare the car for work (see "Preparing the car for maintenance and repair").

2. Lift and remove the decorative engine cover together with the rubber couplings.

2. Lift and remove the decorative engine cover together with the rubber couplings.

Note: If one or more sleeves remain on the studs, remove them and insert them into the corresponding holes in the cover plate.

Note: If one or more sleeves remain on the studs, remove them and insert them into the…

Installation

We install the cover on the engine and, having made sure that all the couplings of its fastening are put on the studs of the intake module, we press on the cover from above until it is fixed.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Kirill Dementyev

◀ Previous

Lada Vesta 1: Engine repair

Next ▶

Engine Oil and Oil Filter — replacement
Engine oil level — check
Engine oil consumption — check
Compression in engine cylinders — check
Oil pressure — check

Engine Mudguard — Removal and Installation
Accessory Drive Belt — check
Auxiliary Drive Belt — replacement
Timing Belt — Checking Condition
Timing Belt — replacement

More articles with information from manuals for Lada:

• Engine trim panel — removal and installation Lada Kalina Hatchback (2004-2013, VAZ-1119)
• Instrument panel Lada Granta 1 (2011-2023, VAZ-2190)
• Removal and installation soundproofing trim in the engine compartment Lada Priora 1 (2007-2018, VAZ-2170)
• Instrument panel trim Lada Largus 1 (2012-2023)
• Troubleshooting Engine Troubleshooting Lada X-Ray 1 (2015-2022)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors