Rear Wheel Hub Bearing — replacement (Vesta 2180)

The need to perform the work is determined during the inspection of the technical condition of the rear suspension (see "Checking the technical condition of the rear suspension").

To perform the work you will need a plier for internal retaining rings, mandrels with a diameter of 49 and 52 mm.

Sequence of execution

1. Prepare the car for work (see "Preparing the car for maintenance and repair").

2. Remove the rear wheel (see "Wheel replacement").

3. Remove the brake drum (see "Rear brake drums - replacement").

4. Using a puller, remove the bearing retaining ring.

(The text of the article was taken from the website: www.ladaman.ru)



5. Using a 0 49 mm mandrel, press the bearing out of the brake drum.

6. Apply a thin layer of plastic grease to the bearing seating surface and its outer ring.



7. Using a ∅ 52 mm mandrel, carefully press the bearing into the brake drum without allowing it to slant.





8. Install the retaining ring.



9. Install the brake drum and tighten the hub nut to a torque of 175 Nm.

10. Install the wheel.