Figure 7-1 - Front suspension anti-roll bar: 1 - stabilizer cushion bracket mounting bolt (subframe mounting bolt); 2 - stabilizer cushion bracket mounting nut; 3 - stabilizer strut; 4 - stabilizer bar mounting nut; 5 - Anti-roll bar link; 6 - stabilizer cushion mounting bracket; 7 - stabilizer cushion
Removal
Place the vehicle on a two-post lift, apply the parking brake and turn off the ignition (spanner 10, electro-hydraulic lift type P-3.2G with lifting capacity of 3.2 t).
Install a transmission stand under the rear part of the subframe and press the subframe (transmission stand type OMA 604, "Avtospetsoborudovanie", Pskov).
Loosen nuts 2, Figure 7-1, securing the stabilizer bar cushion brackets (replacement head 10, extension and ratchet).
Loosen bolts 1 securing the stabilizer bar cushion brackets and remove brackets 6 (rear subframe mounting bolts) (replacement head 18, extension and ratchet).
Loosen the nut 4 bolts securing the anti-roll bar to the front suspension arm (torx T40 angle wrench, 13 mm replaceable head, ratchet wrench).
Remove the stabilizer bar components from the front suspension arm: lower rubber-metal hinge 5, Figure 7-2, mounting bolt 1, two rubber bushings 4, upper rubber-metal hinge 2 and washer 3.
Original is available on this resource LADAMAN
Figure 7-2 - Removing the anti-roll bar: 1 - stabilizer bar mounting bolt; 2 - upper rubber-metal hinge; 3 - washer; 4 - rubber bushings; 5 - lower rubber-metal hinge; 6 - stabilizer bar mounting nut; 7 - front suspension arm; 8 - Anti-roll bar link
Disconnect the anti-roll bar from the front suspension arm on the other side.
Remove the anti-roll bar from the vehicle.
Installation
Caution: Reusing stabilizer bar bracket mounting bolts (front suspension subframe mounting bolts) not allowed. Bolts must be replaced.
Attention: Check the condition of the struts and anti-roll bar cushions and replace if necessary.
Install the anti-roll bar on the vehicle, install the stabilizer cushion brackets and tighten the bracket mounting nuts (replacement head 10, extension and ratchet).
Loosen the bolts securing the stabilizer bar cushion brackets without tightening them (rear subframe mounting bolts) (replacement head 18, extension and ratchet).
Figure 7-3 - Installing the anti-roll bar: 1 - clamp Sus. 1413 and Sus. 1734
Install the anti-roll bar strut elements on the lever: washer, upper rubber-metal hinge, install two rubber bushings between the lever and the stabilizer. Install the mounting bolt, the lower rubber-metal hinge, tighten the package of rack elements with a clamp and screw in the nut without tightening it (clamp Sus. 1413 and Sus. 1734, Torx T40 angle key, replaceable head 13, ratchet key).
Remove the clamp.
Install the anti-roll bar on the other side.
The order of tightening the anti-roll bar fastening elements:
- 1 - stabilizer strut mounting nuts. Tightening torque of nuts 14 Nm (1.4 kgf·m) (torx T40 angle wrench, replaceable head 13, torque wrench);
- 2 - bolts for fastening the anti-roll bar cushion brackets.
Tightening torque of bolts 105 Nm (10.5 kgf·m) (replaceable head 18, extension, torque wrench).
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.19, 1.19.22.