Removal
Place the vehicle on a two-post lift, turn off the ignition and apply the parking brake (electro-hydraulic lift type P-3.2G with a lifting capacity of 3.2 t).
Figure 14-1 - Removing the wheel: 1 - wheel; 2 - wheel mounting bolts
Loosen bolts 2, Figure 14-1, securing wheel 2 (replacement head 17, extension and ratchet).
Raise the vehicle to a height convenient for performing work.
Loosen the wheel mounting bolts and remove the wheel (replacement head 17, extension and ratchet).
Installation
Install the wheel on the hub and tighten the four mounting bolts without completely tightening them (replacement head 17, extension and ratchet).
Lower the vehicle and tighten the wheel mounting bolts completely. Tighten the bolts diagonally. Tightening torque of bolts 90...120 Nm (9.0...12.0 kgf·m) (replaceable head 17, torque wrench).
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934-2006, paragraphs 1.19.19, 1.19.23 in the scope of work performed.