Sequence of execution
1. Prepare the car for work (see "Preparing the car for maintenance and repair") and disconnect the wire terminal from the negative terminal of the battery (see "Battery - Removal and Installation").
2. Press the lock 1 and disconnect the wiring harness block from the absolute pressure and air temperature sensor.
We inspect the connector and make sure there is no damage or oxidation on its terminals. If necessary, we treat the terminals with a special agent to clean and protect electrical contacts.
3. Using a Phillips screwdriver, unscrew the mounting screw 2 and remove the sensor
Note: The connection is sealed with a rubber ring, which must be pressed down each time the sensor is removed.
4. Install the sensor in reverse order. Before installation, apply a thin layer of motor oil to the sealing ring.