Figure 11.3. Lock, drive rods and rear door handles: 1 – outer handle rod; 2 – outer handle; 3 – intermediate locking rod; 4 – intermediate lock lever; 5 – lock button pull; 6 – inner handle; 7 – inner handle pull; 8 – internal lock; 9 – external lock; 10 – outer lock cover
The lock, drive rods and handles of the rear door are shown in the figure 11.3.
You will need: an 8 mm spanner, flat- and Phillips-head screwdrivers, and pliers.
1. Disconnect the wire from the negative terminal of the battery.
2. Remove the rear door trim (see "Removing and installing the rear door trim").
3. Squeeze the shoe retainer…
4. …and disconnect the wiring harness connector of the door lock motor reducer.
5. Remove the three screws securing the inner door handle.
6. Move the handle away from the inner door panel.
(Material was taken from the website: «LADAMAN.RU»)
7. Squeeze the tie rod end retainer…
8. …and disconnect the rod end from the inner handle of the lock.
9. Using a screwdriver, disconnect the intermediate lock rod holder from the door.
10. Remove the screw securing the intermediate lock lever.
11. Lower the intermediate lever down and remove the lock button rod from the bracket hole.
12. Remove the glass guide mounting bolt…
13. …and remove the guide from the door.
14. Use a screwdriver to pry up the end of the outer handle rod and disconnect the rod from the lock lever.
15. Remove the outer door lock cover.
16. Remove the two screws securing the outer lock…
17. …and remove the lock.
18. Remove the screw securing the inner lock...
19. …and remove the inner lock with the locking rods and the inner handle.
20. Install the lock in the reverse order of removal, having first lubricated all rubbing parts with consistent grease. Check the ease of opening and the reliability of closing of the door lock. If necessary, adjust the lock in the same way as adjusting the front door lock (see "Adjusting the front door lock").