Note: The door is quite heavy and bulky, so we recommend removing and installing it with an assistant.
When replacing a door, remove all hardware from the old door and transfer it to the new door.
1. Disconnect the wire from the negative terminal of the battery.
2. Remove the front door trim (see "Removing and installing the front door trim").
3. Disconnect the window regulator wiring harness connector.
4. Disconnect the door lock motor gearbox wiring harness connector.
5. Remove the wire harness mounting clamps from the holes in the inner panel.
6. Pull the wire harness through the opening in the front of the door.
7. Using a 10 mm socket wrench, unscrew the two bolts securing the door opening limiter to the body pillar.
8. Using a 13 mm socket wrench, unscrew the bolts securing the upper and lower door hinges to the front body pillar and remove the door.
Full article on the website LADAman
9. Install the door in reverse order. Before finally tightening the bolts securing the hinges to the body pillar, close the door and position it so that the gaps in the openings around the entire perimeter are the same. Then carefully open the door and finally tighten the hinge mounting bolts. Check the ease of opening and the reliability of closing the door lock, adjust the lock if necessary (see "Adjusting the front door lock").