Windscreen washer pump — removal and installation (Granta 2190)

You can check the serviceability of the windshield washer pump by applying 12 V voltage directly from the battery to its terminals. The faulty pump must be replaced.

Removal

1. Prepare the car for work ("Preparing the car for maintenance and repair").

Advice: If there is a lot of antifreeze in the tank, in order to save money, you can remove the washer reservoir (see below) and, without removing the electric pump, pour the liquid into a canister.

2. Disconnect the two wire blocks from the windshield washer electric pump (after marking the block connected to the "+" terminal).



3. Disconnect the elastic tube from the pump.



4. Using a screwdriver, remove the electric pump from the hole in the tank.



5. Check the condition of the rubber seal installed in the tank opening. If replacement is necessary, remove the seal and install a new one.

Installation

We install the windshield washer electric pumps in the reverse order.