Removal
Place the vehicle on a two-post lift, apply the parking brake, turn off the ignition and disconnect the battery ground terminal (electro-hydraulic lift type P-3.2G with lifting capacity of 3.2 t, spanner 10).
Remove the front right bumper mudguard in accordance with the requirements of TI 3100.25100.20599.
Press the spring clamps of the tube connectors 2 and 5, Figure 8-34, and by moving along the axis of the fittings, disconnect the tubes from the adsorber 1.
Figure 8-34 - Disconnecting the tubes and wiring harness connector from the canister: 1 - adsorber; 2 - fuel vapor recovery tube; 3 - breather tube; 4 - Wiring harness connector to the purge solenoid valve of the adsorber; 5 - adsorber tube
Disconnect breather tube 3 from the adsorber.
Disconnect block 4 of the electromagnetic valve from the adsorber.
Unscrew the two nuts 1, Figure 8-35, securing the adsorber and remove the adsorber 2 from the vehicle (replacement head 13, extension, ratchet).
Figure 8-35 - Removing the adsorber: 1 - adsorber mounting nuts; 2 - adsorber
Installation
Install the adsorber 2, Figure 8-35, on the vehicle, install and tighten the adsorber mounting nuts 1 (replacement head 13, extension, ratchet).
Connect block 4, Figure 8-34, of the electromagnetic valve to the adsorber.
Connect the breather tube 3 to the adsorber.
Connect tubes 2 and 5 to the adsorber by moving along the axis of the fittings until the spring lock of the connector clicks. Check the reliability of the tubes.
Install the front right bumper mudguard in accordance with the requirements of TI 3100.25100.20599.
Connect the ground wire terminal to the battery (spanner 10).
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.6, 1.19.14.
[For more details, see the page LadaMan]