Removal
Place the vehicle on a two-post lift, apply the parking brake, turn off the ignition and disconnect the battery ground terminal (electro-hydraulic lift type P-3.2G with lifting capacity of 3.2 t, spanner 10).
Remove the engine crankcase protection in accordance with the requirements of TI 3100.25100.20594.
Loosen bolt 1, Fig. 11-6, securing the rear engine mount to the front suspension subframe (replacement head 18, extension, ratchet).
Figure 11-6 - Removing the rear engine mount: 1 - bolt securing the rear engine mount to the front suspension subframe; 2 - bolt for fastening the rear engine mount to the gearbox; 3 - rear engine mount support
Loosen bolts 2 securing the rear engine mount support to the gearbox and remove the rear support 3 (replacement head 18, extension, ratchet).
Installation
Install the rear support 3 of the engine mount and tighten the bolts 2 securing the rear support (replacement head 18, extension, ratchet).
Tighten to the specified torque:
- bolt 1 fastening the rear engine mount to the front suspension subframe 105 N·m (10.5 kgf·m);
- bolts 2 fastening the rear engine mount to the gearbox 105 N·m (10.5 kgf·m) (replaceable head 18, extension, torque wrench).
Main material on the website [LadaMan]
Install engine crankcase protection in accordance with the requirements of TI 3100.25100.20594.
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, clause 1.19.6, in the scope of work performed.