Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the front wheel (see "Wheel replacement").
3. Disconnect the sensor wiring harness from the holders on the body.
4. Press the lock and disconnect the wiring harness connector from the sensor.
We disconnect the sensor block from the holder on the inner side of the body side member.
5. Inspect the connector and make sure there is no corrosion or damage. If necessary, we treat it with a special cleaning agent for electrical contacts and clean its contacts from oxides.
6. Disconnect the sensor wiring harness from the holder on the stand.
7. Clean the wheel speed sensor and the surface around the sensor from dirt.
8. Using a TORX T30 key, unscrew the mounting bolt and remove the sensor.
Note: Keep the sensor away from magnets as this may cause damage.
Installation
9. Install the new sensor in reverse order.