Attention! Perform the work after the additional muffler has cooled down to a safe temperature.
To carry out the work, you will need an inspection pit or overpass
Removal
1. Prepare the car for work ("Preparing the car for maintenance and repair").
2. Clean the threaded connections of the jet rod with a metal brush and treat with penetrating lubricant.
3. Using a 13 mm socket wrench, unscrew the two nuts securing the bracket.
4. Remove the bracket.
5. Using a 13 mm socket wrench, unscrew the bolt securing the torque rod to the base of the gearshift lever ball joint, holding the bolt nut with a 13 mm open-end wrench. Similarly, unscrew the second bolt securing the torque rod.
6. Move the rod away from the gear shift lever support.
7. Using a 13 mm wrench, loosen the torque rod clamp. Having disconnected the tip from the CC rod, we remove the rod.
8. If necessary, use a 19 mm socket wrench to loosen the two nuts securing the torque rod bracket, holding the bolt heads with a wrench of the same size. We remove the bracket together with the tip of the jet rod.
Installation
We install the jet thrust in the reverse order.