Technical characteristics of the car (XRAY 1)

Technical characteristics of the car

Technical specifications	Meaning
Overall dimensions, mm: length width height (at curb weight)	4165 1764 1570
Vehicle base, mm	2592
Front track, mm	1484 (R15") – 1492 (R16" and R17")
Rear track, mm	1524 (R15") – 1532 (R16" and R17")
Front overhang, mm	834
Rear overhang, mm	739
Approach/Departure Angle (at full load), hail.	21/34
Ground clearance (at full load) under engine crankcase, mm	≥195
Luggage compartment volume, passenger version/with folded rear seats/with rear and front passenger seats folded, dm3	361/1207/1514
Curb weight (with driver), kg	1190–1250
Complete (permitted maximum) vehicle weight, kg	1650*
Trailer weight with brakes/without brakes, no more than kg	800/600**

Technical specifications	Meaning
Engine	H4M 1.6 l, 16 cl.	H4M 1.6 l, 16 cl.	21129 1.6 l, 16 cl.	21179 1.8 l, 16 cl.	21179 1.8 l, 16 cl.	21179 1.8 l, 16 cl.	21179 1.8 l, 16 cl.
Transmission	JH3-512 MT	JH3-512 MT	JR5-518 MT	21827 AМТ	21827 AМТ	JR5-523 MT	JR5-523 MT
Equipment	Optima	Top	Optima	Optima	Top	Optima	Luxe
Maximum speed***, km/h	181		176	186		185
Acceleration time from 0 to 100 km/h***, s	11,1		11,4	10,9		10,4
Fuel consumption in the combined driving cycle****, l/100 km	6,8		7,2	6,8*****		7,2	7,4
Fuel tank capacity, l	50
Tire size	195/65R15, 205/55R16, 205/50R17

Notes:

• Permissible deviation of overall dimensions is ±1%.
• The permissible deviation of the vehicle weight is +3%. The lower limit is not limited. The maximum speed tolerance is ±5%.
• The permissible deviation in acceleration time is +6%. The permissible deviation in fuel consumption is +10%.

* The maximum weight of the vehicle with a driver.

** Provided that the vehicle is equipped with a coupling device in accordance with the requirements of UNECE Regulation No. 55-01. The mass of the road train (vehicle + trailer with cargo) may not exceed 2405 kg.
*** Measured using a special method.
**** Obtained during tests on running drums. Serves only for comparison of different models of cars and IS NOT AN OPERATING STANDARD. Explanation: For more detailed information on the indicated fuel consumption, see. in the section "Actual fuel consumption".
***** In AMT mode "a".

Actual fuel consumption

The specified fuel consumption of the vehicle in the combined cycle was determined under laboratory conditions (using special measuring equipment) in accordance with the requirements of GOST R 41.101-99 (UNECE Regulation No. 101), is used to compare cars from different car manufacturers and is NOT AN OPERATIONAL STANDARD!

The actual fuel consumption of the vehicle may differ from that declared by the manufacturer due to the impact of various objective and subjective factors on the vehicle. Such factors include: humidity, pressure and temperature of the surrounding air, terrain, road surface characteristics, wind direction and speed, precipitation, fractional composition of the fuel used, selected gears, duration of operation of the air conditioning system, position of window glass, air pressure in tires, their size, brand and model, weight of the transported cargo, including the driver and passengers, presence of a towed trailer, its gross weight and aerodynamic resistance, driving style of the driver (frequency and intensity of longitudinal and lateral accelerations, average vehicle speed), the presence of an autostart system in the car (including the engine and/or interior heating system), running-in of a new vehicle (for models with the "Gear Shift Assistant" function, it is recommended to ignore the "Gear Shift Assistant" requirements during the vehicle running-in period).



It is also recommended periodically (once a month/quarter) reset the vehicle's on-board computer readings.

Due to prolonged engine idling (traffic jam, long engine warm-up time, etc.) and low mileage of the car, there is a significant increase in the readings of the on-board computer, which calculates the average fuel consumption based on the hourly consumption of the engine and the distance traveled by the car (since the last reset of the on-board computer). The need to reset the on-board computer and the frequency is determined by the person operating the vehicle.

General technical characteristics of the power unit

Technical characteristics of the internal combustion engine

Name of the indicator (characteristics)	Values of the indicator (characteristics) for internal combustion engines
	H4М	21129	21179
Working volume, cm3	1598	1596	1774
Number of cylinders, pcs.	4	4	4
Number of valves per cylinder, pcs.	4	4	4
Compression ratio	10,7	10,45	10,3
Octane number of gasoline	95
Maximum engine power according to GOST 14846 [4], kW	81	78	90
Crankshaft speed at maximum power, min-1	5500	5800	6050
Maximum torque according to GOST 14846 [4], N·m	150	148	170
Crankshaft speed at maximum torque, min-1	4000	4200	3700
Minimum idle speed, min-1		840
Fuel cut-off crankshaft speed, min-1	6200	6200	6200
Toxicity standards	EURO 5
Minimum cold engine start temperature without additional devices,°C	– 27

Gearbox specifications

Transmission type	4x2, front-wheel drive and interwheel differential
Transmission	AMT (21827)	MT (JR5 518)	MT (JR5 523)	MT (JH3 512)
Gearbox control drive	Robotic	Cable
Gear ratios
I	3,636	3,727	3,727	3,727
II	1,950	2,048	2,048	2,048
III	1,357	1,321	1,321	1,393
IV	0,941	0,971	0,971	1,029
V	0,784	0,795	0,756	0,756
Reverse	3,500	3,545	3,545	3,545
Main gear	3,938	4,500	4,214	4,357

Masses of internal combustion engines and gearboxes

Unit		Weight, kg
ICE	H4М	92,5
	21129	110,7
	21179	111,0
Checkpoint	MT (JH3 512)	33,0
	MT (JR5 518, JR5 523)	34,0
	AMT (21827)	33,1

Nominal filling volumes

Unit	Volume, l
Fuel tank	50
Engine lubrication system
• 21129 (cast oil pan)	4,15 (3,85)*
• 21179 (cast oil pan)	4,15 (3,85)*
• H4М	4,7 (4,2)*
Engine cooling and cabin heating system**	7,0 (6,4)
• 21179/21129
• H4М	7,0 (6,3)
Transmission:
• AMT 21827	2,25
• MT JH3 512	2,34
•MT JR5 518, JR5 523	2,2
Clutch and brake hydraulic system	0,559
Hydraulic brake system (for configurations with AMT)	0,517
Windscreen washer reservoir	4,7
Expansion tank (complete with engine 21129)	5,75 (max) – 5,35 (min)
Ozone-safe freon R134 "A" in the air conditioning system	0,475±25

* When first filling a dry engine (when changing oil and oil filter).
** The use of mixtures of coolants of different brands is not permitted.

Fuel

It is permitted to use only unleaded gasoline according to GOST R 51866-2002 and GOST 32513-2013.

The preferred fuel for your car is 95 octane gasoline. This gasoline allows you to achieve the nominal values of power, dynamics, economy and toxicity. If it is not possible to use gasoline with an octane rating of 95, it is permissible to use gasoline with an octane rating of at least 92.

Motor oil

In Table 1 below, determine the quality level and viscosity grade of oil prescribed for your vehicle in accordance with the existing operating temperature range. If necessary, change the oil. To do this, please contact your LADA dealer.

Use only recommended operating and lubricating fluids. For information on recommended working and lubricating fluids, please contact your LADA dealer.