Removal
Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (spanner 10).
Remove the steering wheel and steering column covers in accordance with the requirements of TI 3100.25100.20595.
Overcoming the resistance of the clamps, pull the upper part of the shield 2, Figure 5-1, of the instrument panel towards you and remove the shield.
Figure 5-1 - Removing the instrument cluster: 1 - instrument panel; 2 - instrument panel shield; 3 - self-tapping screw; 4 - instrument cluster
Unscrew the two screws 3, self-tapping fastenings of the instrument cluster 4 to the instrument panel 1 (torx T20 bit, screwdriver).
[Taken from the website: Ladaman.ru]
Remove the instrument cluster 1, Figure 5-2, from the instrument panel 2, disconnect the instrument panel wiring harness connector 3 from the instrument cluster connector and remove the instrument cluster.
Figure 5-2 - Connecting the Instrument Panel Wire Harness to the Instrument Cluster: 1 - instrument cluster; 2 - instrument panel; 3 - Panel wiring harness connector
Installation
Install the instrument cluster in the reverse order of removal.
Install the steering column covers and steering wheel in accordance with the requirements of TI 3100.25100.20595.
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.21.3, 1.19.21, 2.3.