Car repair AvtoVAZ Car repair Renault Car repair Hyundai Car repair Ford Car repair Volkswagen Car repair Audi Car repair Chevrolet
English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
articles sitemap contacts bookmark
LadaMan.ru
 
 
 
 
 
 
Kalina Granta Priora Vesta Largus XRAY
X-Ray 1 (2015-2022)

EMM system failures (XRAY 1)

  • Main
  • XRAY
  • X-Ray 1
  • Electrical equipment
  • Equipment and devices
  • EMM system failures
0

List of DTC codes



Default code

Default type

Code name DTC

REAR_WIPER_AUTOSTOP

Error

reliability

signal

REAR_WIPER_FAILURE


1.1.1 List of DTC codes



Below are all DTCs for the front and rear wiper.

Code name

Code

Failure type

Description

DTC

DTC_CSW_Wip_ Fail Ext

$92

$70

$96

Internal component failure

DTC LIN RLS S CG

$92

$21

$11

General electrical. refusal

Short circuit to ground

Detection of short circuit to ground

DTC_LIN_RLS_F

ault

$92

$21

$81

General electrical. refusal

Bus off.

Tire LIN out of order

DTC_Rain_Sensor Fail Ext

$92

$36

$93

Mechanical

refusal

Rain sensor failure

Rain sensor diagnostics

DTC_Light_Senso r Ext

$92

$36

$96

Mechanical

refusal

Light sensor failure

Diagnostics

sensor

illumination

REAR_WIPER

$95

$A0

$64

Algorithm related failure

Error

reliability

signal

Login diagnostics autostop (hitchhiking) rear

windshield wipers

DTC PWR WIP

ER_SCG_Ext

$92

$1D

$11

General electrical failure

Short circuit to ground

Detection of short circuit to ground

DTC_Wiper_Mot or Blocked Ext

$92

$38

$97

Mechanical

refusal

The system or component is malfunctioning or blocked

Detection

blocking

engine


1.1.2. Code activation conditions



The code below is only available if the following conditions are met.

Code name DTC

Parameter condition

Meaning

REAR_WIPER

REAR_WIPER_CF

0: OFF / 1: ON



1.1.3. Reading frame



The following data can be read using the diagnostic tool:
  • bCM calibration parameters,
  • bCM configuration parameters,
  • bCM inputs/outputs listed in the table below:

Name

Type

Description

Meaning

parameter

I_RR_WASHER_SW

I

Electrical state 0 or 12V to request the driver to turn on the washer

0: OFF / 1: ON.

I_RR_WIPER_SW

I

Electrical state 0 or 12V to request the driver to turn on the reverse intermittent mode

0: OFF / 1: ON.

I RR AUTOSTOP SW _

I

Electrical state 0 or 12V rear hitchhiking

0: OFF / 1: ON.

I FR AUTOSTOP S

W _ _

I

Electrical state 0 or 12V front hitchhiking

0: OFF / 1: ON.

I_FR_WASHER_SW

I

Electrical state 0 or 12V to request the driver to turn on the washer

0: OFF / 1: ON.

I_FR_INT_WIPER

I

Electrical state 0 or 12V to request the driver to turn on the intermittent mode of the front windshield wiper

0: OFF / 1: ON.

O_RR_WIPER

O

Activation of the electric windscreen wiper motor command Available only if REAR WIPER CF = 1

0: OFF / 1: ON.

O_FR_LS_WIPER

O

Activation of the electric motor command

z/windscreen wiper, if Wiping by EMM = False.

0: OFF / 1: ON.


Defect

ny

element

Failure type

I may be the reason

Consequences for the driver or the system

Diagnostics

Help

Recommendations

BMC

Refusal BCM

Cm. BCM

It doesn't work

w/windscreen wiper

Cm. BCM

Cm. BCM

Cm. BCM

Loss of information from

rear AF (version with tailgate)

wiring - Engine Failure - BCM Failure

W/windscreen wiper

stops and does not work

REAR WIPE R

-check the electrical wiring between BCM, relay and CSW

check the power supply BCM and the engine

EMM

Refusal EMM

Cm. EMM

The windshield wiper does not work

Cm. EMM

Cm. EMM

Cm. EMM

Loss of information from the front AF

electrical wiring - engine failure - failure EMM

Windscreen wiper in low speed mode

No DTC

-Check the electrical wiring between EMM, relay and CSW -Check the power supply EMM, BCM and the engine

RLSS

Internal failure RLSS

interior

refusal

sensor

-defective

electrical wiring

block

nutrition

-failure LIN

communications

-Loss of information from the rain sensor -Request for manual windshield wiper mode with CSW still possible

DTC_Rain_S ensor Fail E xt

DTC_Light_

Sensor_Ext

DTC_LIN_R

LS_SCG

DTC_LIN_R

LS_Fault

-Check the electrical wiring between RLS and EMM

-Check the power supply RLSS -Check the vehicle configuration (without/with RLSS)

Before

replacement

sensor

necessary

o

disconnect the battery

CSW

CSW

disconnected

internal failure CSW -defective electrical wiring between CSW and emM

-defect

connectors

- Front and rear do not work

windshield washer

Cm. EMM

-Check the electrical wiring between BCM and CSV

-Check the power supply CSV -Check the connectors CSV


Defect

connectors

between CSV and

front and

back

windshield washer

Disconnecting the connector or

electrical wiring

- Front and rear do not work

windshield washer - speed reduction mode does not work

No DTC

Check the electrical wiring between CSV

Correspondents

CAN

CAN lost or

"not available"

or

"reserved"

-Problem

CAN

-Error

Entry/Exit CAN

BCM

-Error

Entry/Exit CAN

EMM

-APC off: Not

works

glass cleaning

-APC on:

supported

last

request

Cm. CAN

-Cm.

Recommendations for CAN -Check the I/O wires from BCM and EMM

LIN

Loss LIN

-Wiring problem -See. LIN

Windscreen wiper speed reduction mode:

- the last request is supported if the car is in motion

windshield wipers do not work after the car stops (APC off)

Cm. DED LIN

-Check the electrical wiring between RLSS and BCM

-Cm. DED Lin

Cm. DED Lin



This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Daniil Markelov
Share with friends:
◀ Previous
Lada X-Ray 1: Equipment and devices
Next ▶

Low Speed Switch CSW EMM System
High Speed Switch CSW EMM System
Functions performed by the EMM system
Functional description and diagnostics of the EMM system
Error codes of the Central Control Module of cars
Electrical equipment — design and operation features
Battery — removal and installation
Starter — removal and installation
Generator — removal and installation
Instrument cluster — removal and installation
More articles with information from manuals for Lada:

• Cooling system reference data Lada Kalina Hatchback (2004-2013, VAZ-1119)
• Remote control system Lada Granta 1 (2011-2023, VAZ-2190)
• Features of the interior heating and ventilation system Lada Priora 1 (2007-2018, VAZ-2170)
• Engine Management System — Design Description Lada Vesta 1 (2015-2023, VAZ-2180)
• Anti-lock braking system ABS Lada Largus 1 (2012-2023)
Link to this article in various formats
Reviews and comments of visitors
No comments yet


Add up two numbers: 41 + 24

       



X-Ray 1 (2015-2022) 
  • General information
  • User manual
  • Maintenance
  • Daily care
  • Troubleshooting
  • Power unit
  • Engine repair
  • Fuel system
  • Cooling system
  • Repair H4M engine
  • Transmission
  • Clutch and drive shafts
  • Transmission
  • Chassis (running gear)
  • Front suspension
  • Rear suspension
  • Brake system
  • Steering
  • Body and interior
  • Exterior (external elements)
  • Interior (internal elements)
  • Electrical equipment
  • Equipment and devices
  • Lighting and signaling
LadaMan.ru © 2018–2026 | Mobile version | About Lada | Sitemap: EN BG BY UA RS HR RO PL SK HU | Contacts with admin | | Add to bookmarks
Kalina Hatchback (2004-2013) | Kalina Sedan (2004-2013) | Granta 1 (2011-2023) | Priora 1 (2007-2018) | Vesta 1 (2015-2023) | Largus 1 (2012-2023) | X-Ray 1 (2015-2022) |
This site uses cookies to ensure everything runs smoothly.