Note. The type of engine oil used is given in appendix 2.
Attention! Before checking the oil level after a trip, stop the engine and wait 3-5 minutes until the oil drains into the sump.
Attention! Add oil of the same brand, viscosity and quality class as the one used previously.
Attention! The oil level in the engine crankcase must not exceed the upper mark on the indicator (dipstick), Otherwise, gaskets and seals may leak, causing increased oil consumption.
Attention! Check the oil level with the vehicle parked on a level surface.
The oil filler plug is located on the front left side of the cylinder head cover. Oil gauge (probe) located at the front center of the engine.
1. Take out the pointer (probe) …
2....wipe it with a clean cloth and reinsert it.
3. Remove the dipstick again. The oil film level must be between the upper and lower marks. If the oil level is at or below the lower mark, add oil.
4. To add oil, unscrew the oil filler cap.
5. Fill the engine with oil while checking the oil level using the dipstick. Before removing the pointer, wait 3-5 minutes to allow the oil to drain into the crankcase.
6. After the oil level reaches the required level, tighten the filler cap.