Front seats
To adjust the front seats in the longitudinal direction, pull the locking lever 1 (figure 9a) up. After setting the seat in a comfortable position, lower the lever and, by slightly moving the seat back and forth, achieve its secure fixation.
For detailed recommendations on the correct installation of front seats from the point of view of passive safety, see the section "Airbags".
Warning! Do not adjust the driver's seat while the vehicle is moving. The seat may move suddenly, resulting in loss of control of the vehicle.
The seat backrest tilt is infinitely adjustable by turning handle 2.
In the optional design, the front seats are equipped with electric heaters, which are switched on when the engine is running using switches 1 (figure 9b). To turn on the driver's seat heating, press the left switch; to turn on the passenger seat heating, press the right switch.
The heating is turned off by pressing the switch again. The control light located on the switch key will glow yellow during the entire time the heater is operating.
Headrest adjustment (figure 10) in height occurs by direct action on the headrest. The headrest is adjusted downwards by pressing the headrest lock lever 1 on the right side. To remove the head restraint from the seat back, move the head restraint to its highest position and press both locking levers 1 and 2 of the head restraint on the right and left sides.
The optimal position of the headrest is when its upper edge is level with the top of the head. If this cannot be achieved, for very tall people the headrest should be raised to the highest position, and for very short people it should be lowered to the lowest position.
Rear seats
To increase the area of the luggage compartment, it is possible to fold the rear seat (figure 11a). In the variant version, each of the two parts of the seat can be folded out separately if necessary.
Before folding the rear seat (or parts thereof) it is necessary to pass the tapes of 2 rear side belts (figure 11b) through holders 1 tapes (in a variant design), remove the middle seat belt tongue from the mini buckle (see figure 14b) and install all rear seat belt buckles into the buckle holders located at the bottom of the seat back. The middle seat belt tongue is removed by pressing a sharp object, such as an ignition key, on the button on the side of the mini-lock.
After returning the rear seat to its working position, the seat belt buckles must be removed from the holders and the tongue of the middle seat belt must be inserted into the mini-buckle, aligning the arrows.
Warning: Do not allow the rear side belts to be behind the rear seatback when returning it to its working position to avoid damage to the belt webbing by the seatback buckle.
Unfold the rear seat in the following sequence:
- in the variant version, remove the headrests from the seat back (the rear seat head restraints are adjustable and removable in the same way as the front seat head restraints);
- pull loop 4 (figure 11a) and set pillow 1 in a vertical position. If necessary, move the front seats forward;
- pull the handle 3 of the lock drive and place the backrest 2 in a horizontal position.
To install the rear seat into the working position, perform the following steps in reverse order.