To lock the side doors and turn on the security mode, press the lock button
on the remote control. In this case, the side door locks will be locked, and the security mode will be activated, which is confirmed by a single flashing of the direction indicators and a slow flashing of the immobilizer status indicator 
in the instrument cluster.
If any side door, hood or other vehicle is open when the security mode is activated, (in a variant design) trunk lid/tailgate, the direction indicators will flash three times and a single beep will sound. To include open zones in the security zone, close them. The system will behave similarly if the protection against overheating of the side door locks is triggered if the locking (unlock) locks occur repeatedly over a short period of time. In this case, wait for some time, after which the system will be fully operational.
2. Unlocking the side door locks and disabling the security mode using the remote control.
Unlocking the side doors of the car using the remote control is possible in two modes:
- step unlocking (factory supply);
- simultaneous unlocking (a specific procedure needs to be followed - see below).
In the step unlock mode, press the unlock button from the remote control to unlock the driver's door lock and disarm the vehicle
on the remote control. The driver's door lock is unlocked, and disabling the security mode is accompanied by a single flash of the direction indicators.
To unlock the passenger doors, press the unlock button
on the remote control again.
In the simultaneous unlock mode, the first press of the unlock button will unlock all side doors of the vehicle simultaneously.
Changing the unlock mode is done using the following procedure:
- turn on the ignition with the key and remote control;
- simultaneously press and hold the lock buttons on the remote control for about 5 seconds and unlocking side doors;
- after the buzzer sounds, release the buttons.
If one buzzer signal sounds, the mode of simultaneous unlocking of the side doors is set; if two buzzer signals sound, the mode of stepwise unlocking of the side doors is set. Each time you change the unlock mode, it changes to the opposite of the one set previously.
If after disabling the security mode none of the side doors, the hood, the trunk is opened and the ignition is not turned on, then after a certain time (about 30 seconds) the side doors will be locked again and the system will automatically switch to security mode. The ability of the system to automatically switch to security mode with door locking is reflected by frequent flashing of the immobilizer indicator
in the instrument cluster.
3. Opening the trunk lid/tailgate lock with the remote control (in a variant design).
Opening the trunk lid/tailgate using the remote control is only possible when the ignition is off. To open the trunk lid/tailgate, press the button twice with a short interval or press and hold the button for a while
on the remote control.
When the security mode is on, opening the trunk lid/tailgate occurs simultaneously with disabling the trunk/tailgate security zone. The trunk lid/tailgate security zone is activated in the security mode 2 seconds after the trunk lid/tailgate is closed.
4. Central locking and unlocking of side door locks from the passenger compartment (in a variant design).
To lock the side door locks from inside the car, press the lock button in the driver's door or (in a variant design) press the lock button
in the driver's door module. In configurations with a driver's door module, locking the side doors from the button in the driver's door is only possible when the ignition is off.
To unlock the driver's door lock from inside the vehicle, lift the lock button in the driver's door. To unlock all side doors (in a variant design) press the unlock button
in the driver's door module.
The central locking has protection for the side door locks from overheating. If the locks are locked and unlocked repeatedly within a short period of time, the system will stop responding to button presses. If this happens, do not press the button for a while, after which the system will fully recover. For security reasons, the last command executed is always the unlock command.
5. Central locking/unlocking of side door locks from outside the vehicle (without remote control).
To lock the side door locks from outside the vehicle, turn the key in the driver's door lock clockwise. Turning the key counterclockwise will unlock either the driver's door or all side doors, depending on the unlocking mode (see point 2).
Attention! If it becomes necessary to lock or unlock the side door locks mechanically (for example, lack of power in the vehicle's electrical system) need to:
- to lock the front doors, press button 1 (see figure 4a, 4b, 5a and 5b) manually or by turning the key from outside the car, to unlock the lock, pull out button 1 manually or by turning the key from outside the car (locking/unlocking the front doors is only possible when the door is closed);
- on the rear doors manually press button 1 (see figure 7a and 7b) to lock the lock, pull out button 1 to unlock the lock (locking/unlocking the rear doors is possible both with the door closed and with the door open).
6. Operation of the system in security mode.
After turning on the security mode, the system monitors the status of the following security zones:
- side doors;
- hood;
- trunk lid/tailgate;
- ignition switch;
- driver's door lock;
- battery voltage.
If any of the following actions occur in the security mode:
- opening any side door;
- opening the hood;
- opening the trunk lid/tailgate;
- turning on the ignition without using "your" key;
- driver's door unlock;
- when connecting the battery after disconnecting it, the alarm is activated in the form of a light signal from the turn signals and an audible signal from the standard sound signal of the car for about 30 seconds.
Pressing any button on the remote control once when the system is in alarm mode will stop the alarm signals, but the system will remain in the security mode. The security mode is turned off after pressing the unlock button
on the remote control.
7. Remote control of electric window lifters (in a variant design).
Electric windows are controlled by the remote control buttons when the ignition is off.
The windows are raised while the lock button is held down
in the pressed position for more than three seconds. First the front windows are raised, then the rear doors.
The windows are lowered while the unlock button is held down
in the pressed position for more than three seconds. First the front windows are lowered, then the rear doors.
Warning: Do not give the remote control to children to prevent unauthorized operation of the electric windows. When raising and lowering the windows using the remote control, remember that the remote control in this mode operates in a short-range area from the vehicle. This is related to safety and ensuring protection against accidental pinching of passengers remaining in the cabin by glass.
8. Resynchronization of key codes.
In cases where the remote control buttons are pressed outside the radio channel coverage area, the counter of the "floating" code in the remote control goes out of synchronization with the counter in the system control unit. If the number of remote control button presses outside the system's signal reception area exceeds 1000, the system will stop responding to remote control commands. In this case, the remote control retraining procedure should be repeated on a certified PSSS.