But it is difficult to perform such a check when the electric fan is located in the air conditioner housing. Interferes with the location of the connector. You can apply voltage using two wires, at the ends of which there are lugs for putting on plugs.
The wires will have to be connected by touch. It is desirable to insulate the tip of the wire connected to the positive terminal of the battery.
Another way is to remove the electric fan to check. But in this case, before testing, it must be securely fixed to the body. In this case, the fan impeller should not touch anything.
Warning! To avoid injury, do not touch the impeller when applying voltage.
Removing
1. We prepare the car for work («Preparing the car for maintenance and repair»).
2. Remove the glove box for ease of use (see «Additional resistor - replacement»).
3. Pressing the latch...
... we disconnect the block of wires from the electric fan.
4. Unscrew the three screws securing the electric fan.
5. Remove the electric fan from the air conditioner.
Installation
Install the fan in reverse order.