Removal
Place the vehicle in the work area, apply the parking brake and turn off the ignition.
Disconnect the ground wire terminal from the battery (spanner 10).
Disconnect connector 1, Figure 8-13, of the wiring harness from valve 3 of the adsorber purge.
Figure 8-13 - Evaporative Canister Purge Valve: 1 - Wiring harness connector to the purge valve of the adsorber; 2 - steam pipe to the intake module; 3 - purge valve of the adsorber; 4 - steam pipe from the adsorber
Press the spring clamps of the tip of tube 2 of the steam line to the intake module and, by moving along the axis of the fitting, disconnect the tube from the purge valve of the adsorber.
Press the spring clamps of the tip of tube 4 of the steam line from the adsorber and, by moving along the axis of the fitting, disconnect the tube from the adsorber purge valve.
Remove the purge valve from the bracket on the car body together with the damper.
If necessary, remove the damper from the purge valve of the adsorber.
Installation
Install the purge valve of the adsorber in the reverse order of removal.
When installing the steam pipes, connect the pipe tips to the adsorber purge valve fittings until the spring lock clicks. After installation, check the reliability of the tubes.