Removal
Place the vehicle on a two-post lift, apply the parking brake and turn off the ignition (electro-hydraulic lift type P-3.2G with a lifting capacity of 3.2 t).
Remove the front wheel in accordance with the requirements of TI 3100.25100.20594.
Raise the vehicle to a height convenient for performing work.
Remove the front brake disc in accordance with the requirements of paragraph. 7 of this TI.
Unscrew the three bolts 1, Figure 8-1, securing the front brake disc casing and remove the casing 2 (torx T30 replacement bit, extension, ratchet wrench).
Figure 8-1 - Removing the brake disc cover: 1 - brake disc casing mounting bolts; 2 - brake disc casing
Installation
Install the front brake disc cover and secure it to the steering knuckle with three bolts. Tightening torque of bolts 7...9 Nm (0.7...0.9 kgf·m) (torx T30 replacement bit, extension, ratchet wrench, torque wrench).
Install the front brake disc in accordance with the requirements of paragraph. 7 of this TI.
Install the front wheel in accordance with the requirements of TI 3100.25100.20594.
Press the brake pedal 2-3 times, check and, if necessary, top up the brake fluid level in the brake hydraulic reservoir.
Check the efficiency of the service brake system in accordance with the requirements of TI 3100.25100.13062.
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.9, 1.19.22 in the scope of work performed.