Removing
Place the vehicle on a two-post lift, apply the parking brake and turn off the ignition.
Remove front wheel.
Raise the vehicle to a height convenient for work.
Remove front brake disc (see here).
Unscrew three bolts 1, Figure 12-1, fastening the front brake disc cover and remove the cover 2 (replaceable nozzle Torx T30, extension, ratchet wrench).
Figure 12-1 - Removing the brake disc cover: 1 - bolts of fastening of a casing of a brake disk; 2 - casing of the brake disc
Installation
Install the front brake disc cover and secure it to the steering knuckle with three bolts. Bolt tightening torque 7 Nm (0.7 kgf·m) (replaceable nozzle Torx T30, extension, ratchet wrench, torque wrench).
Install the front brake disc.
Install the front wheel.
Press the brake pedal 2-3 times, check and, if necessary, top up the level of brake fluid in the reservoir of the hydraulic brake drive.
Check the efficiency of the service brake system.