Sequence of execution
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the door trim (see "Door trim - removal and installation").
3. Remove the inner glass seal.
(Article copied from the resource: LADAman.ru)
4. Using a 10 mm wrench, unscrew the glass guide mounting bolt.
5. Disconnect the seal from the guide...
...and we take it out of the door.
6. Disconnect the guide from the upper holder and remove it.
7. Connect the electric window control button to the block and lower the door glass until the glass mounting bolts align with the technological holes.
8. Unscrew the two bolts securing the glass to the holder.
9. Pull the glass upwards and remove it.
10. Install the parts in reverse order. Before finally tightening the glass mounting bolts, we make sure that it is installed correctly by raising and lowering the glass several times.