Depending on the configuration, other switches may be installed on the overlay.
Removal
1. Center console trim ("Instrument cluster center console trim - removal and installation").
Note: To replace a faulty switch, you do not have to remove the center console trim completely. It is enough to disconnect it from the instrument panel, move it a short distance and disconnect the block from the switch being removed and remove the faulty switch. You can check the switches and the switch with a multimeter in ohmmeter mode. The connection of the terminals is shown in the general diagram of the vehicle's electrical equipment ("Electrical equipment diagrams").
2. To remove the hazard warning switch from the back of the trim, squeeze the two clips...
...and remove the switch from the hole.
3. To remove the rear window heating switch, also squeeze the clips...
...and remove the switch from the cover hole.
4. To remove the climate control switch, squeeze the clamps...
...and remove the switch from the cover.
Installation
1. Install the switches into the center console trim until the latches snap into place. When installing the rear window heating switch, orient it so that the symbol on its button is not upside down. We orient the climate control switch according to the mark on it and the positions on the front side of the cover. The hazard warning switch can only be installed in one position.
2. Install the central console trim onto the instrument panel.