2.1 General conditions
2.1.1 The radio receiver may only be operated if there is complete confidence that this will not pose a threat to road safety.
Attention! First and foremost, pay close attention to the road! The driver bears full responsibility for road safety. Use the product in such a way that the car remains under your control in any situation!
2.1.2 To prevent an accident while driving:
- do not tune the radio receiver;
- do not make the sound too loud, as this may interfere with the perception of sound signals from other vehicles.
2.1.3 Try to avoid parking the vehicle in places exposed to direct sunlight, which may lead to excessive temperature rise inside the vehicle. Allow the interior temperature to cool before starting playback.
2.1.4 The radio receiver is designed to operate at ambient temperatures from minus 40°C to plus 70°C. Before use, the temperature inside the vehicle must reach acceptable limits.
2.1.5 The radio receiver is designed for connection to the vehicle's 12 V on-board network with a minus on the body. Do not connect the radio to vehicles with different power voltage.
2.1.6 The USB connector is designed to connect a USB Flash card, USB Flash player with a memory capacity of at least 1024 MB, USB HDD with the FAT 32 file system and Mobile phone (only in charging mode).
2.2 Turning the radio on/off
2.2.1 To turn the radio receiver on or off, briefly press the "+" button (pos. 4). After switching on, the radio receiver will go into the mode preceding switching off.
2.2.3 If the radio does not respond to pressing the control buttons, press (with a blunt thin rod) and hold the Reset button for 2-3 seconds (figure 2, pos. 12). After turning on the button
(figure 2, pos. 4) the radio receiver automatically switches to radio listening mode.
Attention! The radio receiver saves user settings (radio frequencies, sound settings, user settings) after disconnecting the battery terminals no more than 10 days.
2.3 Sound settings
2.3.1 Volume control is performed by rotating the encoder knob (figure 2, pos. 6) to the right or to the left.
2.3.2 By briefly pressing the encoder knob you enter the sound settings mode. The parameter to be adjusted is selected by turning the encoder knob.
2.3.3 To turn off the sound, press the MUTE button (figure 2, pos. 3). To turn the sound on, press the button again or turn the encoder knob.
2.4 Time display
2.4.1 If you press the DISP button (figure 2, pos. 9), then the current time will be shown on the display for 15 seconds only when the ignition is on.
2.5 Welcome screen when turning on the radio
2.5.1 When you turn on the radio, a welcome message appears on the screen "LADA GRANTA".