6.1 Setting up audio parameters
6.1.1 This mode is entered by briefly pressing the encoder while in the "main window" (playback window).
6.1.2 Switching and changing the parameters is carried out by rotating the encoder in the following order: Equalizer → Low frequency tone → High frequency tone → Balance → Front/rear balance → Loudness compensation → Output.
Note: The adjustment mode will exit automatically if the user has not made any adjustments for 5 seconds.
6.2 Adjustment window for the selected audio parameter
6.2.1 Entering this mode is done by pressing the encoder on the corresponding menu item. The selected parameter is adjusted by rotating the encoder knob.
6.2.2 The equalizer settings are made in the following order: EQ JAZZ → EQ POP → EQ CLASSIC → EQ VOCAL → EQ USER.
6.2.3 The range of adjustments for the LF, HF, Balance, and Front/Rear Balance is from "-7" to "+7" units.
6.3 System settings
6.3.1 Through the system settings menu you can:
- set time display format (clock mode);
- set current time manually (setting hours/minutes);
- on/off function of correcting the current time by RDS signals (RDS CT);
- turn on/off the radio automatic switching function to an alternative frequency (RDS AF);
- turn on/off the function of searching radio stations by a given program type (RDS PTY);
- turn on/off the function of receiving regional radio stations (RDS REG);
- on/off CB range (AM range);
- turn on/off Bluetooth function (connecting bodies);
- on/off button press confirmation signal (signal);
- turn on/off noise reduction function (noise reduction);
- reset the radio receiver settings to factory settings (reset).
6.3.2 Entering the system settings mode is done by long pressing the encoder while in the "main window" (playback window). The selection of available settings and adjustment of the selected parameter is done by rotating the encoder. Entering the adjustment of the selected parameter and confirming the setting is done by briefly pressing the encoder.
6.3.5 You can exit the system settings mode using the "Exit" menu item or automatically (if the user has not made any adjustments within 5 seconds).