Removal
Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Lift the hood, disconnect the ground wire terminal from the battery.
Figure 17-3 - Radio apparatus: 1 - radio apparatus
Remove radio 1, Figure 17-3, from the instrument panel using two special pullers (radio puller 7711381821 - 2 pcs.). Or using four pins, inserting them into the holes by about 3 cm (see photo) and pressing on them simultaneously (thin nails, knitting needles, etc. will do.).
Holes for inserting keys (pins).
Disconnect connector 1, Figure 17-4, of the wiring harness from radio 2.
Disconnect cable 3 of the radio antenna from the radio.
Figure 17-4 - Removing the radio (radio apparatus): 1 - wiring harness block to the radio; 2 - radio; 3 - radio antenna cable
Installation
Install the radio in the reverse order of removal. At the same time...
...the head unit pin with the rubber bushing placed on it should enter the hole in the instrument panel.
Attention. For normal operation of the radio, when installing, make sure that the antenna cable and wires are not compressed, twisted or deformed.