Removal the front seat (right or left)
Move the seat to the rearmost position.
Unscrew the two bolts 1, Figure 9-1, of the front mount of the skids to the body (torx T30 replaceable head, ratchet).
Move the seat to the forwardmost position.
Unscrew the two bolts 2 of the rear mount of the skids to the body (torx T30 replaceable head, ratchet).
Figure 9-1 - Removing the front seat: 1 - front runner mounting bolt; 2 - bolt for rear mounting of skids
Lift the seat and disconnect the wiring harness holder from the seat frame.
Disconnect the seat heating wiring harness connector.
Remove the front seat with the runners assembly.
Removal the rear seat (second row seats)
Second row rear seats (middle row) can be filmed separately.
Figure 9-2 - Rear seat mounting: 1 - rear seat mounting bolts; 2 - pin; 3 - eye
Remove the rear headrests.
Disengage the seatback locking latches and fold the rear seat.
Loosen two bolts 1, Figure 9-2, securing the rear seat (replacement head 13, extension, ratchet).
Move the seat to the side, disengaging pin 2 of the rear seat from engagement with eye 3.
Remove the rear seat assembly.
Removal the third row rear seat
To fold the left backrest, lower the headrest completely.
Pull up the lock lever...
...and fold the back forward. Fold the right back in the same way.
To fold the seat, pull the fabric loop of the lock catch completely...
...lift the pillow up...
...and recline the seat forward until it rests against the second row seats.
To completely remove the seat in the reclined position, pull back the levers of the two support locks.
Raise the seat by removing its support locks from the brackets on the body base...
...and remove the seat from the passenger compartment.
Installation
Install the seats in the reverse order of removal.
(Original publication on the website: www.ladaman.ru)
When installing the third row rear seat into the passenger compartment, slide the support locks onto the brackets and fold the seat back. At the same time, the levers of the support locks will automatically turn to the working position and secure the seat.
When installing the front seats, apply "Fiol-1" grease to the rubbing surfaces of the runners. Consumption rate is 10 g per seat.